Handle Position; Moving The Machine - Husqvarna DMT 700 Operator's Manual

Handle position

CAUTION! Never use the handlebars to lift the saw.
Use the handlebars to maneuver the saw.
The position of the handlebars can be adjusted in height and
length.
• Loosen the locking knob A to adjust the length.
• Turn handle adjustment locking knob B counterclockwise
to unlock and reposition handlebar. Turn clockwise to lock
handlebar in position. Set handle to most comfortable
working height. Tighten the locking knob.

Moving the machine

Prior to moving the machine, read and understand section
"Starting and stopping".
Moving the machine with the engine off
• Turn Engine start switch to the ignition on position.
• Raise the saw by pressing up the Raise/lower switch on
the Speed control lever until the blade (if installed) clears
the pavement surface.
• Put Speed control lever into the STOP position.
• Set the Transmission bypass valve counterclockwise to
the up (neutral) position.
• The saw can now be moved by standing behind it and
pushing (while holding the handlebars).
OPERATING
B
A
WARNING! Do not attempt to push the saw
!
while it is in neutral position on a grade (or
hill). The saw operator could lose control of
the saw and cause injury to oneself or other
persons in the area.
Moving the saw with the engine on
• Turn Engine start switch to the ignition on position.
• Raise the saw by pressing up the Raise/lower switch on
the Speed control lever until the blade (if installed) clears
the pavement surface.
• Put Speed control lever into the STOP position.
• The Engine throttle is at idle speed setting per default.
• Ensure that the Blade clutch is disengaged (if clutch
installed).
2
1
3
4
<1200 RPM
12 80
10 14 60 100
WORKING HOUR
8 16 40 120
V V c c
CURRENT: STOP:
0 4
cm cm
CAUTION! Pay special attention on
!
clutchless machines, blade starts rotating at
start. For safety reason, do not move the
saw sideways or out of the working area with
blade installed and rotating.
• While the Engine start switch is in the ignition on position,
check the display and ensure that preheat symbol is
turned off. If it is lit, the glow plugs warm the engine and
the engine will not start. Wait a few seconds until turned
off.
– 17
English