Husqvarna DMT 700 Operator's Manual page 40

C1D0311 Blade clutch
C1D0615 Water pump
C1D0611 Water pump
C1D0915 Working light
C1D0911 Working light
C1D0C15 Ignition
C1D0C11 Ignition
Hydraulic lift
C1D0D15
pump
Hydraulic lift
C1D0D11
pump
Hydraulic
C1D0E15
lowering valve
Hydraulic
C1D0E11
lowering valve
40 –
English
TROUBLESHOOTING
Circuit short to
ground
Circuit short to Water pump can not be controlled by
battery or open the HMI. May not be able to turn on.
Circuit short to
Water pump can not be turned on.
ground
Circuit short to
battery or open
Working light can not be controlled
by the HMI. May not be able to turn
Circuit short to
on.
ground
Circuit short to
battery or open
Engine can not be started.
Circuit short to
ground
Circuit short to Hydraulic lift pump can't be used for
battery or open raising the blade.
Circuit short to Hydraulic lift pump can't be used for
ground raising the blade.
Circuit short to
battery or open
Hydraulic lowering valve can't be
used for lowering the blade.
Circuit short to
ground
Check damage to X14 connector,
harness to relay/fuse box and relay/fuse
box connector. If found, repair and
restart system, reset fault code.
If problem still exists, contact your
service agent for further information.
Check K2 in relay/fuse box.
Check damage to X14 connector,
harness to relay/fuse box and relay/fuse
box connector. If found, repair and
restart system, reset fault code.
If problem still exists, contact your
service agent for further information.
Check working light relay K3 in relay/
fuse box.
Check damage to X14 connector,
harness to relay/fuse box and relay/fuse
box connector. If found, repair and
restart system, reset fault code.
If problem still exists, contact your
service agent for further information.
Deutz:
Check damage to X14 and X1
connector and harness. If found, repair
and restart system, reset fault code.
If problem still exists, contact your
service agent for further information.
Check K6 in relay/fuse box.
Check damage to X14 connector,
harness to relay/fuse box and relay/fuse
box connector. If found, repair and
restart system, reset fault code.
If problem still exists, contact your
service agent for further information.
Check that hydraulic valve is properly
connected.
Check damage to X14 connector,
harness and hydraulic valve. If found,
repair and restart system, reset fault
code.
If problem still exists, contact your
service agent for further information.
Check damage to X14 connector,
harness and hydraulic valve. If found,
repair and restart system, reset fault
code.
If problem still exists, contact your
service agent for further information.