Troubleshooting - STEINEL IS 3180 Manual

IS 3180 IS 3360/
IS 3360 MX
Reaches Basic IS 3360
setting 1: max. 20 m
max. 8-20 m tangential;
tangential; temperature
temperature stabilised
stabilised
IS 3360 MX
Basic max. 18 m;
setting 2: temperature
max. 4-8 m; stabilised
temperature
stabilised + precision
adjustment
+ precision using shrouds
adjustment
by moving the
lens and Half-
round clip-on
shroud
Detection 7 11
levels
Switching zones 448 1416
Time setting 5 s - 15 min + pulse mode (approx. 2 s)
Twilight setting 2-1000 lux + teach mode
Manual override selectable (4 h)
(permanent light)
IP rating Surface-mounted: IP54 Concealed: IP20
Temperature -20°C to +50°C
range:
*
Fluorescent lamps, low-energy lamps, LED lights with electronic ballast
(total capacity of all ballasts connected below the level stated).
IS 345 IS 345 MX
max. 20 x 4 m max. 30 × 4 m
(tangential), (radial) mounted
max. 12 x 4 m at a height
(radial); of 12 m;
temperature temperature
stabilised stabilised
+ precision + precision
adjustment adjustment
using shrouds using shrouds
5 5
280 120
34
11� Troubleshooting
Malfunction Cause
No power at the sensor
n Fuse faulty, not
switched ON,
break in wiring
n Short circuit
Sensor will not switch ON
n Twilight setting set to
night-time mode during
daytime operation
n Bulb faulty
n Mains power switch
OFF
n Fuse faulty
n Detection zone not
properly targeted
Sensor will not switch OFF
n Continuous movement
in the detection zone
n Light being operated
is located in detection
zone and keeps switch-
ing ON as a result of
temperature change
n Light being operated
is in manual override
mode (LED ON)
Sensor keeps switching
n Light being operated is
ON/OFF located in the detec-
tion zone
n Animals moving in the
detection zone
Sensor reach n Change in ambient
change temperatures
Remedy
n New fuse, turn ON
power switch, check
wiring with voltage tester
n Check connections
n Adjust setting
n Change bulb
n Switch ON
n Fit new fuse, check
connection if necessary
n Readjust
n Check zone, adjust or fit
shrouds if necessary
n Change detection zone
or fit shrouds
n Deactivate
manual override
n Change zone
or fit shrouds,
increase distance
n Change detection zone
or fit shrouds
n Use shrouds to define
detection zone precisely
35