Installation - Assembly Oven - PizzaMaster 700 Series Instructions For Installation, Operation And Maintenance

Assembly for ovens with legs
Tip! If possible, use a forklift truck to lift the oven to fit
the legs. Alternatively, lift the oven manually on to a
strong table or flat bench, so that the legs can be fitted
safely.
Minimum lift height for fitting of legs:
1-deck oven 1105 mm
2-deck oven 935 mm
3-deck oven 765 mm
4-deck oven 425 mm
Approximate weights:
1-deck oven 200 kg
2-deck oven 350 kg
3-deck oven 500 kg
4-deck oven 650 kg
Important!
Do not remove the wooden supports for the
hearthstones until you reach point 7 opposite.
Do not use the oven-door handles or the oven-
vent knobs to lift the oven, for it can damage the
oven.
APPLIANCE MUST BE SECURED TO BUILDING
STRUCTURE.
The appliance must be installed with an adequate
restraining to limit the movement of the appliance
without transmitting stress to the electrical conduit.
The restraining must be fastened in one of the
supports leg or spacers as shown in the figure
below.
The appliance must be installed with a flexible
conduit.
3
5
4
PizzaMaster®
Installation – Assembly oven
Warning!
Make sure all 12 bolts for assembly the legs on to
the oven are in place and proper tightened, before
moving the oven.
The oven can otherwise tip over when moving it.
Important! Fit the 2 legs with the lockable wheels to
the front of the oven, and the 2 legs with non-lockable
wheels to the rear.
1. Lift the oven and fit the legs using the M10x30 bolts
(12 pcs) + 20x10.5 washers (12 pcs) provided.
For each leg, first screw in (but do not tighten) the
internal bolt, i.e. the one that has to be inserted
through the top inside of the leg. Then screw in the
2 external bolts, but do not tighten. Now tighten the
3 bolts progressively and alternately to fix the leg
firmly to the oven.
2. Fit the slide rails (4 pcs) to the legs as shown below,
using the self-tapping screws (hexagonal) provided
(16 pcs).
3. Insert the sliding shelf into either the upper or the
lower pair of rails, as required. (1 sliding shelf is
supplied as standard)
Depending on oven model it is possible to install up
to 2 work top shelves. Any installed worktop shelf
must be secured with 2 stop plates.
4. Fit the steam duct, using the screws (wafer head)
provided (no. of screws depending on model).
5. Fit the flue diverter, using the self-tapping screws
(wafer head) provided (3 pcs).
6. Fit the Top side panel (2pcs), using self-tapping
screws (wafer head) (4pcs)
7. Remove the wooden supports that hold the hearth-
stones in place.
8. Remove all protective plastic film from the oven.
6
2
1
7