First-Time Start-Up / Changing Of Oven Lamps / Maintenance - PizzaMaster 700 Series Instructions For Installation, Operation And Maintenance

First-time start-up / Changing of oven lamps / Maintenance

First-time start-up of oven
Before putting the oven into operation, it should be
switched on and brought up to temperature to burn off
any remaining protective oil in the oven chamber(s).
When this is done, the oven will emit a certain amount
of smoke, which is normal. Make sure therefore that the
kitchen ventilation system is switched on. If possible,
open doors and windows to allow the smoke to escape
more quickly. All decks can be switched on simultane-
ously. Follow the running-in schedule below:
1. Close all the oven doors, open all the oven vents
and adjust the thermostat to 330
2. Turn all heat controls to position 10 and switch on
the oven by turning its main switch into position 1.
3. When the oven reaches 330
30 minutes), leave it switched on for 1 hour.
4. The oven is now ready for use. For temperature- and
heat-control settings, please see pages 16 - 19.
Changing an oven lamp
IMPORTANT!
If the oven is hot, take great care not to burn yourself.
Take care not to touch the new lamp directly, for that
would reduce its service life.
1. Switch off the oven by turning the main switch into
position 0.
2. Remove the lamp glass.
3. Take out the defective lamp.
4. Wear gloves or use a piece of paper to grasp and fit
the new lamp.
5. Fit back the lamp glass.
6. Switch on the oven by turning the main switch into
position 1.
C.
o
o C (which takes about
PizzaMaster®
How to remove door gasket for cleaning or
replacement.
PM 700/800/900
Door gasket
Remove door gasket
For replacement of door gasket it is necessary to use
a screwdriver with Phillips Head.
Remove all screws on both left and right hand side
and on the side A (see image) of the oven door.
Remove door gasket.
IMPORTANT! when replacing the old gasket make
sure the old gasket is fully removed.
Installation of door gasket
Place the gasket in the gap between the door frame
and the stainless steel parts. Make sure the gasket is
left out with 8mm/0.3in as shown in the image.
Fasten gasket and stainless steel parts by attaching
all screws.
A
21