Hcec Setup - LG LV30 Z Series Installation Manual

30

HCEC SETUP

HCEC SETUP
Installation Menu (V 3.0)
LG Hotel Mode Setup
TV Manager
Password Change
Set ID Setup
Configuration Setup
Time Scheduler
Lock Mode
External Speaker
HCEC Setup HCEC Setup
Insert Image
Welcome Video
S/W : 00.02.00.01 Micom : 0.00.32
y Use the button to select the HCEC Setup.
1 HCEC Setup
y When 'HCEC Setup' is set to 'HCEC Mode', You can adjust 'IR Decoding', 'Device ID', 'Stand By' menu and
y
SIMPLINK feature automatically changed to the ON state, and the user can not change this status.
- IR Decoding
y When 'IR Decoding' is set to 'Yes', the TV decodes and changes it into a CEC Message and sends it to
y
Command via the HDMI CEC Line. The default value is No.
- Device ID
y Sets the ID of a device(Logical Address) connected to the CEC Line. You can choose
y
between 'All' and 'E'.
y The default value is 'All'.
y
- Stand By
y Sets the sending and receiving scenario of the operation about [CEC Op standBy(0x0c)
y
Command(Device Power)].
y The detailed scenario is described on the table below.
y
Send Only
Receive Only
All
OFF
2 HTNG HotelMode
y If the following options are selected because of the HTNG command:
y
*Power On Default, Start Volume, Maximum Volume, Minimum Volume, or Start Volume,
then the value for the HTNG HotelMode changes automatically to Yes and, even if the HotelMode is set to No,
the above options are still affected.
y If you change it to No, then the values set by the HTNG will be canceled.
y
3 Forced Initialize (* Only for LV5**H series)
y If 'No' is selected, a command should be sent and received between the TV and a -device for proper
y
initialization.
y If 'Yes' is selected, initialization is implemented when a device receives a command.
y
If initialization is not implemented, the TV remote control and local key will work.
HCEC Setup
CEC Mode
IR Decoding
Device ID
StandBy
Forced Initialize
HTNG HotelMode
Previous
OK
Send Receive
O
X
O
X
Default
◄
No
All
All
No
No
X
O
O
X
►
OK