Hcec Setup; Htng Hotelmode - LG T340C Z Series Installation Manual

28

HCEC Setup

1 Go to General -> HCEC Setup.
HCEC Setup
(1) CEC Mode
• You will have 2 modes to choose Default, HCEC.
• If Default is selected, you can use SIMPLINK which is provided in LG TV. Also you can enable and disable SIMPLINK through SIMPLINK
MENU.
• If HCEC is selected, you can use TVLink-HCEC Protocol. (For more detailed information, please refer to TVLink-HCEC Protocol document)
(2) IR Decoding
• When IR Decoding is set to Enable, the TV decodes and changes it into a CEC Message and sends it to Command via the HDMI CEC Line.
The default value is Disable.
(3 Device ID
• Sets the ID of a device(Logical Address) connected to the CEC Line. You can choose between All and E.
• The default value is All.
(4) Stand By
• Sets the sending and receiving scenario of the operation about [CEC Op standBy(0 x 0c) Command(Device Power)].
• The detailed scenario is described on the table below.

HTNG HotelMode

• If the following options are selected because of the HTNG command:
* Power On Default, Start Volume, Maximum Volume, Minimum Volume, then the value for the HTNG HotelMode changes automatically to
Enable and, even if the HotelMode is set to Off, the above options are still affected.
• If you change it to Disable, then the values set by the HTNG will be canceled.
All
Send Only
Receive Only
Off
Send Receive
O
O
X
X
O
X
O
X