Installation And Switching On The Appliance; Before Switching On - Nordmende RET340R Instruction Booklet

• Do not touch the cooling surfaces, especially with wet hands as
you could be burnt or hurt.
• Do not eat ice, which have just been removed from the freezer.
• This application is optional for easy opening door.
With this application, a little condensation may occur
around this area and you may take it out.

Installation and Switching On The Appliance

• This appliance is connecting to 220-240V and 50 Hz.
• You can offer help from the service to install and switching on the appliance.
• Before making the connection to the power supply,ensure that the voltage on the
name plate corresponds to the voltage of electrical system in your home.
• If the socket does not match the refrigerator plug, replace the plug with a suitable one
(at least 16 A)
• Insert the plug into a socket with an efficient ground connection.
If the socket has no ground contact, we suggest you call an
electrician for assistance.
• Manufacturer is not responsible for failure to complete the
ground connection as described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to the rain.
• Place the refrigerator far from heat sources and in a well-
ventilated position. The refrigerator should be at least 50 cm
from radiators,gas or coal stoves and 5 cm far from electrical
stoves.
• Keep the top free for at least 15 cm.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another refrigerator or freezer,
observe a minimum distance of 2 cm to prevent condensation.
• Fit the plastic wall spacers to the condenser at the back of the
refrigerator in order to prevent leaning to the wall for good
performance.
• The appliance must be stand firmly and level on the floor Use
the two front levelling-feet to compensate for an even floor.
• The outside of the appliance and the accessories inside should be cleaned with a
solution of water and liquid soap ; the inside of the appliance with sodium bicarbonate
dissolved in lukewarm water. After drying replace all the accessories.

Before Switching On

• Wait after 3 hours before plugging the appliance in to the main
power to ensure proper performance.
• There can be an odour when you first switch on the appliance. It
will disappear after the appliance starts to cool.
EN - 4 -