Mitsubishi E-45P Service Manual page 77

MOOEL LT45P
DISASSEMBLY PROCEDURE FOR LT'45P
1. Removing the bottom cover
1) As shown in Fig' 9, the bottom cover can,
be removed
by removing the five bottom
"ou"'
t""""'
@ '
2. Removing the duit covor
1) The dust cover can be removed by removing
the four
dust cover fixing screws @ at sttown in Fig' 10'
3. Rcmoving the tonearm dtæir
1) Following step 2, removing the dust cover'
2i Rs ,t,own in Fig. 11, the tonearm
chassis can be re-
moved by first removing the four '""*'
(1-Ù '
4. Removing the tonearm bars
1) Following step 3. remove the tonearm
chassis'
2l As shown in Fig. 12. remove the two
'""'n"
6D
and then remove the cover'
3) As shown in Fig' 12, remove the two
'"'"*t
6à
and then remove the guide shaft'
4) Since the tonearm base is sttached to
the dial cord' re-
move the E-ring, and then remove the horizontal
gear'
5) Following the above procedure' the
tonearm bæe can
be removed together will the dial cord assembly'
5. Rcmoving the tonearm and phorrc cartrklge
The tonearm can be removed even when
the tonearm
bæe is attached to the tonearm chæsis'
1) As shown in Fig.
'13. remove the wo screws
@
' and
then remove the tonearm from the tonearm
base'
screws 6à
Tonearm chassis
F'tg.12
Tonearm bese
Tonearm chassis
scret"s @
Fis. 11
Toneôrm âsÉÊmblY
Fie. 13
1 0