Clear Coding; Alarm Setting - Palermo Smart Camera Manual

24/7 PHONE SUPPORT 252-316-0108
submenu step by step Setting, Defense Area, Hall, 1,
and select "1".
Trigger the door magnet then tap OK to trigger the
wireless sensor to code. It will show "operation
successful" if it has been properly coded. If it shows
"operation failed", repeat the process.
After coding is successful, go back to Settings to access
Alarm Settings.
On "receive alarm message", arm the alarm for the
camera. Once the door magnet has been triggered, the
camera will send alarm to the Mobile APP.

CLEAR CODING:

Access to the Defense Area, select the Channel which
needs clearing.
Click the red icon on the right side and confirm to clear the
coding.

ALARM SETTING:

There are two methods to arm the alarm:
1. Press the Coded IR learning remote controller (the
lock button) to arm the alarm.
2. Click the Lock icon on the right side of the Device
name on the mobile APP (Yoosee).
After arming the alarm, the camera will send the alarm
signal to the APP when any alarm is triggered and send
the captured picture to the alarm push email address.
- 25 -