Stand Alone Midi Foot Controller; Using Irig Stomp I/O As Stand Alone Controller (No Computer Required); Pedal Calibration; External Pedal Inputs - IK Multimedia iRig Stomp I/O User Manual

English

5 Stand alone MIDI foot controller

5.1 Using iRig Stomp I/O as stand alone controller (no computer required)

With no device connected, the iRig Stomp I/O can be used to send MIDI messages thru the MIDI OUT port.
Messages sent are the same of generic MIDI controller, but all the MIDI messages are routed to the MIDI OUT
port.
To use the iRig Stomp I/O as a stand alone controller, keep pressed the footswitch 1 while connecting the
external PSU: to indicate that iRig Stomp I/O has been initialized in stand alone mode, all the 4 footswitch's
LEDs blink red 3 times and the red LEDs of the meters turn on red.
In this mode, all the message sent are the same as per paragraph 4 of this manual (Audio/MIDI interface and
)
foot controller , with exception of the tap tempo message that's not sent. The unit will start up in this mode
each time it will be powered on: to exit the stand alone mode keep pressed footswitch 1 while connecting the
external PSU.

6 Pedal calibration

The on-board expression pedal is factory calibrated to offer the best experience. Nevertheless, a user pedal
calibration may be required. Before to perform the pedal calibration, bring the pedal to its minimum position. To
start the calibration process keep pressed the footswitch 3 while powering up iRig Stomp I/O. When the iRig
Stomp I/O is in pedal calibration the pedal's LED blink alternatively in red and green: move the expression pedal
from its minimum to its maximum (please note that the calibration does not consider the virtual switch). To end
the calibration, press any of the footswitches: if the calibration ended up successfully the pedal's LED blinks for
few seconds green, otherwise it will blinks for few seconds red to indicate that something gone wrong during
the procedure.

7 External pedal inputs

iRig Stomp I/O sports two external pedal inputs that can be used to connect expression pedals or sustain
pedals.
The external pedal inputs send:
Expression Pedal 1
Expression Pedal 2
Sustain Pedal 1
Sustain Pedal 2

8 Audio meters

iRig Stomp I/O sports an input level meter to keep monitored the audio input signal, and a device output meter
to keep monitored the signal coming from the connected host.
CC#12
CC#13
CC#64 - momentary action
CC#65 - momentary action
MIDI CH 1
18