the pool due to mishandling or failure to follow these instructions.
ATTENTION: Do not use a high pressure air hose or over-inflate
the top ring, it should be slightly stiff to the touch.
NOTE: Do not use extension power cords to power your pump.
ATTENTION: Do not drag the pool on the ground, this can
damage the pool.
NOTE: The base or bottom of the pool should be laid out
properly (flat without wrinkles).
NOTE: Hot temperatures cause air to expand the ring and may
cause damage. Leave some room for expansion.
Please see FAQ's for additional information.
1
3
5
ATTENTION: Do not leave pool unattended while filling with
water.
Pool walls will rise as you fill with water.
1. Fill pool until water capacity is 80%, DO NOT OVERFILL as
this could cause the pool to collapse. In times of heavy rainfall
you may need to empty some of the water to ensure the level
is correct.
2. When filling the pool is completed, check that the water is not
collecting on any side to ensure the pool is level.
IMPORTANT: If pool is not level, drain water and re-level ground
by digging out. Never attempt to move the pool with water in it,
serious personal injury or damage to the pool may result.
WARNING: Your pool may contain a great deal of pressure. If
your pool has any bulge or uneven side, then the pool is not
level, the sides may burst and the water may discharge suddenly
causing serious personal injury and/or damage to property.
NOTE: Drawings for illustration purposes only. May not reflect
actual product. Not to scale.
Pool Maintenance
If you do not adhere to the maintenance guidelines below, your
health might be at risk, especially that of your children.
IMPORTANT: If you don't respect the ideal values of the
water chemicals the PVC can be damaged and become
discolor.
The following table lists the sequence of the tests that should be
carried out for the ideal values and possible actions. Regularly
check the pH value and chlorine concentration weekly and adjust
to the ideal values.
2
4
6
80%
0°
TEST
pH value
Cyanuric acid
Free chlorine
Chlorine compound
Algae
Calcium hardness
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase
of chemicals and pH kits. One of the most important factors to
increase the life of the liner is to keep continously clean and
healthy water. Please strictly follow the instructions from
professional technicians for the water treatment through the
use of chemicals.
2. Locate a bucket of water next to pool to clean users' feet
before entering pool.
3. Cover the pool when not in use.
4. Skim pool regularly to avoid settled dirt.
5. Check and wash the filter cartridge regularly.
6. Gently clean any scum from below the top ring with a clean
cloth.
7. Please be careful in case of rain water, kindly check that the
water level is not higher than the expected. If so, YOU HAVE
TO DISCHARGE THE EXCESS WATER.
Proper maintenance can maximize the life of your pool.
During the season of use of the swimming pool, the filtration
system must be necessarily put into service every day, enough
time to assure at least a complete renewal of the volume of
water.
Repair
Check pool for any leaks from valves or seams, check the
ground cloth for any evident water loss. Do not add chemicals
until this has been done.
NOTE: In the event of a leak, patch your pool using the
underwater adhesive repair patch provided. Refer to the FAQs
for further information.
Dismantling
1. Unscrew the drain valve cap counter-clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the
hose in the area where you are going to drain your pool.
(Check local regulations for drainage by-laws).
3. Screw the control ring of the hose adaptor clockwise onto the
drain valve. The drain valve will be open and water will start to
drain automatically. Open the drain valve to the maximum
position.
4. Deflate the top ring by squeezing the air valve.
5. When the top ring is fully deflated, press the top ring down,
and tilt it to drain the pool easily. Completely drain the water in
the pool.
6. When draining is finished, unscrew the control ring to close
the valve.
7. Disconnect the hose.
8. Screw the cap back onto the drain valve.
9. Air dry pool.
Storage and Winterization
1. Please remove all the accessories and spare parts of the pool
and store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to
prevent pool from sticking together, fold pool carefully. If pool
is not completely dry, mold may result and will damage the
pool liner.
3. Store liner and accessories in a dry place with a moderate
temperature between 5ºC / 41ºF and 38ºC / 100ºF.
4. During the rainy season, pool and accessories should be
stored as per above instructions also.
5. Improper draining of the pool might cause serious personal
injury and/or damage to personal property.
6. We strongly recommend the pool is disassembled during the
off season (winter months). Store in a dry location out of
children's reach.
5
IDEAL VALUES
7.4 – 7.6
30 – 50 ppm
2 – 4 ppm
0
None visible
200 – 400 ppm
Need help?
Do you have a question about the FAST SET and is the answer not in the manual?