Vaxcel T0551 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0551 / T0552
W
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d'alimentation principale au panneau
central de disjoncteurs avant d'installer le luminaire.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Cross Bar Unit (A)
Outlet Box
House Grounding Wire
Wire Connector (C)
Cross Bar Unit (A)
Headless Screw
Green Grounding Screw
Mounting Screw (B)
Fixture Grounding Wire
Fixture Wire
Installation steps
Turn off the power at fuse or circuit box.
1. Remove the two bolt nuts (D), the two rubber pads (E) and the cross bar unit (A) from the backplate.
2. Attach the cross bar unit (A) to the outlet box using two mounting screws (B). Adjust the length of the
preinstalled headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally to make the fixture level.
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
• Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
• Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
• Attach the fixture grounding wire (usually green insulation or bare wire) to the cross bar unit (A) with the
green grounding screw. Then, depending on local code connect it to the house grounding wire with the wire
connector (C).
Carefully put all of the wires back into the outlet box.
INSTRUCTIONS
Mounting Screw (B)
Backplate
Wire Connector (C) Bolt Nut (D) Rubber Pad (E)
Bolt Nut (D)
Rubber Pad (E)
191129