Table of Contents
Advertisement
Switch
Down (default)
4
Full Frequency Range
5
LED Steady
Local Mute Control
The microphone ships configured for local (manual) mute control (DIP Switch 3 down). In this mode, the PUSH button on the
microphone mutes the audio signal at the microphone. Audio is not sent to the audio outputs when muted.
In this configuration, the LED color reflects the microphone state, as controlled by the user with the PUSH button.
Microphone Status
Active
Muted
Button Configuration
For local mute control operation, use DIP Switches 1 and 2 to configure the button behavior.
Button Behavior
Momentary: push-to-mute (as shipped).
Momentary: push-to-talk
MX405, 410, 415
Green
Red
SWITCH OUT Logic Signal
When pushed, SWITCH OUT (red wire) falls
to 0 V. When released, SWITCH OUT re
turns to +5 V.
Up
Low Cut Filter (attenuates 6 dB per octave be
low 150 Hz)
LED Flashes
MX405R, 410R, 415R
Red
Off/flashing
DIP Switch Setting
Shure Incorporated
17/25
Advertisement
Table of Contents
