Shure Incorporated Table of Contents RFI Filtering MX400SEGooseneck Microphones Microphone Placement General Description Permanent Installation Model Variations Changing from Side Exit to Bottom Exit Interchangeable Cartridges Flange Shock Mount Snap-Fit Windscreen Specifications Preamp Gain Certifications 2/12...
The MX400SE series can be screwed onto a mic stand or the supplied 5/8 in. 27-threaded flange. They can be easily changed from side exit to bottom exit to conceal the cabling. All models include an in-line preamplifier, a 3.66 m (12 ft.) cable.
Page 4
Shure Incorporated Interchangeable Cartridges Microflex microphones use interchangeable cartridges that allow you to choose the polar pattern for different installations. 4/12...
Provides 30 dB of "pop" protection. Preamp Gain If necessary, the preamplifier gain can be reduced by 12 dB. Contact an authorized Shure service center for information. RFI Filtering Important: Microphones must be used with the RK100PK or RK202PK plate-mounted preamp to optimize RF immunity.
Shure Incorporated • If four or more microphones will be open at the same time, use of an automatic mixer, such as the Shure SCM810 or SCM410, is recommended. Permanent Installation Changing from Side Exit to Bottom Exit Do not cut the cable to reroute. This will compromise RF immunity.
Drill a 44mm(1-3/4 in.) diameter hole in desired mounting surface. Mark and drill starter holes for screws, using shock mount as a template. Secure shock mount to mounting surface with screws. Thread the supplied adapter onto the MX400SE microphone before inserting it into the shock mount. 7/12...
Meets essential requirements of all applicable European Directives. Eligible for CE marking. The CE Declaration of Conformity can be obtained from Shure Incorporated or any of its European representatives. For contact information please visit www.shure.com The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance...