• Cardioid: One microphone for one or two people. • Snap into the groove below the cartridge. Shure MX405, MX410, and MX415 miniature • Supercardioid: One microphone for each person. • To remove, spread the gap with a screwdriver or thumbnail.
The LED logic may not function when connecting to devices MX400DP Desktop Base that do not have internal "pull-up resistor" logic circuits, such as ClearOne DSP products. External pull-up resistor circuits can be added for each microphone. Visit www.shure.com/FAQ for detailed instructions.
Installation MX400DP DIP Switches Button Configuration Caution: Failure to reinstall the setscrew will reduce RF immunity. For local mute control operation, use DIP Switches 1 and 2 to con- figure the button behavior. Button Behavior SWITCH OUT Logic DIP Switch Signal Setting Momentary:...
93 dB Preamp Gain Common Mode Rejection If necessary, the preamplifier gain can be reduced by 12 dB. 10 to 100,000 kHz Contact an authorized Shure service center for information. 45 dB, minimum Preamplifier Output Clipping Level at 1% THD Specifications −8 dBV (0.4 V)
Page 6
1 1/4 in 3/8 in (32 mm) (9 mm) 3/32 in (2.6 mm) 3 5/16 in (84 mm) 14 3/4 in 9 7/8 in 9 in (376 mm) (251 mm) (229 mm) 7/8 in 13 in (343 mm) (22 mm) 6 in 5 1/2 in (152 mm)
Need help?
Do you have a question about the Microflex MX405 and is the answer not in the manual?
Questions and answers