Physio Control LIFEPAK CR Plus Replacement Instructions

Defibrillators

Hide thumbs Also See for LIFEPAK CR Plus:

LIFEPAK CR

How do I replace the QUIK-PAK™ electrode packet on my LIFEPAK CR Plus or

LIFEPAK EXPRESS defibrillator?

Explanation:

Both the QUIK-PAK electrode packet and the CHARGE-PAK™ battery charger should be replaced at the same time after each use of the

defibrillator or when the readiness display shows the

1. Press the ON/OFF button to open the defibrillator lid (voice

instructions will sound).

2. Press and hold down the ON/OFF button for 2 seconds to turn

off the defibrillator voice prompts and save battery power.

3. To remove the old electrode packet, unplug the electrode

connector from the receptacle.

4. Slide the anchor pin from the slot.

5. Discard the outdated or used electrode packet according to lo-

cal regulations or in the trash.

Plus / LIFEPAK EXPRESS

symbol.

DEFIBRILLATORS

Table of Contents

Do you have a question about the LIFEPAK CR Plus and is the answer not in the manual?

Page 1 ® ® DEFIBRILLATORS How do I replace the QUIK-PAK™ electrode packet on my LIFEPAK CR Plus or LIFEPAK EXPRESS defibrillator? Explanation: Both the QUIK-PAK electrode packet and the CHARGE-PAK™ battery charger should be replaced at the same time after each use of the defibrillator or when the readiness display shows the symbol.
Page 2 9. Close the lid. Confirm that the packet “Use By” date is visible through the window in the upper right-hand corner of the lid. Reference: LIFEPAK CR Plus and LIFEPAK EXPRESS Defibrillator Operating Instructions, Section 5.3 Applies to: LIFEPAK CR Plus Defibrillator LIFEPAK EXPRESS Defibrillator For further information, please contact your Physio-Control representative at 800.442.1142 or visit our website at www.physio-control.com...

Lifepak express