JTS CS-W4C Instruction Manual page 9

AF： indicates the current strength of audio frequency signals.
7
RF： indicates the current strength of radio frequency signals.
8
Key lock: push and hold for 2 seconds to lock all keys, and again to unlock.
9
Volume keys：push▲/▼keys to adjust the volume between 0 and -31dB.
10
Selection key：push this button
11
a. Push SETUP to enter the setting for the selected channel for parameter
settings.
b. Push REMOSET to transmit the setting data to the transmitter in this
selected channel.
Logic Controller Output：An external logic trigger device, such as a
12
camera-like trigger device, can be connected.
Ø6.3 audio output jack：unbalanced audio signal output after mixing
13
XLR audio jack：balanced audio signal output
14
XLR audio jack：balanced audio signal output after mixing
Antenna A (B) input terminal：BNC antenna input jack that also provides
15
DC12V/100mA output.
LINK IN： Priority Control Signal and Mixed Signal Input Port
16
LINK OUT： Priority Control Signal and Mixed Signal Output Port
17
AC input： 100~240 VAC
18
Note: Each cacading may bring1.2dB attenuation to RF signal.
AC input cascaded：
19
RF signal A (B) output terminal：
20
RF A (or B) OUT of the first unit to the antenna A (or B) IN of the second unit with a BNC-
BNC signal cable, and then the RF A (or B) OUT of the second unit to the antenna A (or B)
IN of the third unit, and so on and so forth. The cascade may consist of up to 10 units to
minimize the number of antennas used.
5
use AC double power cable (optional) for power cascading.
RF signal output jack; it is possible to connect the