JTS CS-W4C Instruction Manual page 24

Pairing for REMOSET
1.REMOSET：push REMOSET and the blue indicator will start flashing, indicating that
the frequency data is being transmitted.
2.REMOSET successful：the blue indicator lights up on the transmitter for 3 seconds
and that on the receiver stops flashing.
3.REMOSET failed：if the blue indicator flashes slowly on the receiver, check that：
(1) The ''frequency range labels'' on ''both'' the receiver and transmitter are the
same;
(2)''Pairing'' in the function menu of the transmitter is ''activated;''
(3) The ''Device ID'' on the transmitter is the same as that on the receiver; and
(4) Transmitter battery is low (synchronization is impossible when battery is low).
*It should be avoided to have two or more receivers on REMOSET when REMOSET is used, as
sometimes it prevents pairing due to the mutual interference of REMOSET signals.
4.Pairing 4 microphones simultaneously: push REMOSET and the blue indicator starts
to flashing. On the display all 4 receiver channels show ''Synchronizing,'' indicating
that data are being transmitted to all 4 microphones.
CS-W4C
PUSH / CONTROL
SETUP EXIT
CS-W4T
CH1
CS-W4C
LED
20