JTS CS-W4C Instruction Manual page 20

Receiver channel 1
◎Frequency setting
Select the left 3 digits of the frequency; spin the rotary
switch to adjust in the increment of ''+/-'' 1 MHz. Push
the switch to confirm the selection.
Select the right 3 digits of the frequency; spin the
rotary switch to adjust in the increment of ''+/-'' 0.025
MHz. Push SETUP to confirm and save the selection.
◎Default group
Spin the rotary switch to select group ''G:'' through 1 to
6: Push the switch to confirm the selection.
Spin the rotary switch again to select channel
''CH:'' up to 22 channels are available. Push SETUP to
confirm and save the selection.
◎Channel scan
Scan all groups Push the rotary switch to start scanning.
The system goes to the selection page
once the scanning is done. It is also
possible to arrive at here through menu.
Scan result Push the rotary switch to enter the
selection page and examine the result.
Select an available channel and push
SETUP to save the selection.
Scan current The next group will be scanned every
time the rotary switch is pushed. Make
group
the selection and push SETUP to save it.
16