Table of Contents
Advertisement
tare
Clearing stored values
automatically (ACLr)
Permanently storing additional
weight (Pt)
4. Confirm your selection with the Enter key.
The current selection for the menu item or a submenu is displayed (here
level "0").
5. To change your selection or call up another submenu, keep pressing one
of the arrow keys until the required selection is displayed (here: level "2").
6. Confirm the selection with the Enter key.
You will leave the menu automatically.
7. To make further selections, call up the menu again and proceed as de-
scribed above.
NOTE
If no key is pressed for approx. 24 seconds, you will leave the menu
automatically.
To avoid storing obsolete measuring results in the device memory and so cal-
culating the BMI incorrectly, you can set the scales to ensure measured val-
ues are automatically cleared after 5 minutes.
NOTE
With certain models this function is already activated at the factory. If
required, you can disable this function.
1. Select the item "ACLr" in the menu.
2. Confirm the selection.
3. Select the setting you require:
– On
– Off
4. Confirm the selection.
You will leave the menu automatically.
You can use the Pre-Tare function to permanently store an additional weight
and automatically deduct it from the measuring result. You can for example
store a flat-rate figure as the weight of shoes and clothing and then always
deduct it from the measuring result when a patient is weighed fully dressed.
1. Select the item "Pt" in the menu.
The message "Pt" appears.
2. Confirm your selection.
Arrows can be seen flashing in the display.
The additional weight last stored is displayed.
3. You can accept the stored value or adjust it using the arrow keys.
NOTE
If you enter the value "0", the function will be switched off. The
message "Pt" will no longer be displayed.
4. Confirm your selection.
5. Ask the patient to sit down on the scale.
The patient's weight is displayed.
The additional weight stored has been automatically deducted.
6. To disable this function, select the item "Pt" in the menu again.
7. Confirm your selection.
The function is disabled.
You will leave the menu automatically.
NOTE
When you switch the scale off, the function is switched off. The mes-
sage "Pt" is no longer displayed when you switch the scale on again.
English
Operation • 19
Advertisement
Table of Contents
