Deleting Saved Values Automatically (Aclr); Permanently Saving An Additional Weight (Pt) - Seca 664 Manual

tare
Deleting saved values
automatically (AClr)
Permanently saving an
additional weight (Pt)
86 •
4. Confirm your selection with Enter (send/print).
The current setting for the menu item or a submenu
are displayed (in this case: level "0").
5. To amend the setting or call up a different sub-
menu, press one of the arrow keys until the desired
setting (in this case: level "2") is displayed.
6. Confirm the setting with Enter (send/print).
You exit the menu automatically.
7. To make more settings, call up the menu again and
proceed as described.
NOTE
If no key is pressed for about 24 seconds, you
exit the menu automatically.
To prevent current measurement results remaining in
the memory of the device and leading to an incorrect
BMI calculation, you can set the scale so that measure-
ment results are automatically deleted after 5 minutes.
NOTE
This function is activated at the factory on some
models. You can deactivate the function if
desired.
1. Select the item "AClr" from the menu.
2. Confirm your selection.
3. Select the desired setting:
– On
– Off
4. Confirm your selection.
You exit the menu automatically.
This function is suitable for patients who are not mobile
and who will have to be weighed in a wheelchair, for
example. You can save the tare weight of the wheel-
chair independently of a weighing operation. You can
call up the tare weight of the wheelchair during the
weighing operation and have it deducted from the
measured result automatically.