Replacing An Nsp Module - Cisco 6400 Maintaining

Chapter 5 Maintaining the Cisco 6400
Figure 5-8
To install a new screw-type air filter, refer to
Step 1 Hold the air filter with the arrows (located on the metal frame) facing up.
Step 2 Slide the air filter into the bottom tray of the chassis.
Secure the tray by tightening the retaining screws.
Step 3

Replacing an NSP Module

The Cisco 6400 can contain one or two NSP modules, which are located in slots 0A and 0B (in the
middle of the chassis).
Figure 5-9
Removing an active NSP in a redundant configuration causes a switchover. Removing an active NSP
Caution
in a nonredundant configuration causes a system shutdown.
OL-2133-02
Inserting a Tab-Type Air Filter
PO W ER
FA UL T
M IS W IR
E
Figure 5-9 shows the NSP faceplate.
NSP Faceplate
P R O C
E S S O R
O N LY
Figure 5-7 and perform the following steps:
Cisco 6400 Hardware Installation and Maintenance Guide
Replacing an NSP Module
5-11