Table of Contents
Advertisement
Replacing the CMOS Battery
Replacing the CMOS Battery
The M9037A is provided with a 3.0 V "coin cell" lithium battery. This battery
backs up the Real Time Clock. To replace the battery, proceed as follows:
1 Turn off the PXIe Chassis.
2 Remove the M9037A Embedded Controller from the chassis. Observe all
3 Locate and remove the battery (see Figure 14 below). Press the battery
Figure 14 Replacing the Battery
4 Place the new battery in the socket. Make sure that you correctly orient the
Keysight M9037A PXIe Embedded Controller User Guide
Always observe ESD precautions. See
(ESD)"
on page 59.
anti-static precautions.
release latch (1). The battery should pop out (2).
battery for installation. The positive pole (+) must be on the top. You may find
it helpful to angle the battery in and pull back on the battery release latch.
Replace the lithium battery with an identical battery (CR2032 or
equivalent).
Controller Maintenance
"Electrostatic Discharge
1
2
67
Advertisement
Table of Contents
