Table of Contents
Advertisement
Step 6:
You will need for this page:
SS
(QTY: 4)
Position Splice Post at the center of the rear
1
wall and fasten to Rear Wall Angle using four
(4) Small Bolts and Nuts and two (2) Small
Screws to the Floor Frame.
2
Following dimensions, measuring from end of
Rear Wall Angle, place Stud between each
Corner and Splice Post at the rear of building.
Position Stud inside top angle and fasten with
one (1) Small Screw at the lower hole.
3
Place bottom of Stud Assembly over Floor
Frame as shown. Do not fasten bottom at
this time. Repeat procedure for the remaining
Stud Assemblies around the building.
Fasten Door Jambs using four (4) Small
4
Screws, two (2) Small Screws in the Door
Track and two (2) Small Screws in the Floor
Frame. Must be a 7/8" (2,2 cm) gap between
the end of the Ramp and edge of Door Jamb.
Notched edge must face towards the center of
the building.
Splice Post/Door Jamb/ Studs
SB
SS
(QTY: 8)
(QTY: 4)
1
5287
9344
Splice Post
Siding Stud
2
SS
7311
SS
7/8" (2,2 cm) Gap
19
2
2
7311
Door Jamb
SS
9344
5287
29 3/16"
(74,1 cm)
SS
3
NOTCHED EDGE MUST FACE
CENTER OF BUILDING
SS
7311
SS
19DG
SB
1
9344
29 3/16"
(74,1 cm)
4
Advertisement
Table of Contents
