Roof Panel - Arrow Storage Products VD102C Owner's Manual & Assembly Manual

Roof Install Prep Page
Use the information on this page to complete step 12.
Measure the building diagonally again to make
sure the building is square. The building should
be square at the base and at the top. This will
make roof panels fi t better and holes will better
align.
If Roof Beam holes do not line up with Roof
Panel holes, shift the building from left to right. If
this does not help, your building may not be level.
Shim the corners until holes line up.
LEAVE SLOT OPEN
FASTEN TO GABLES
WITH BOLTS AND NUTS
The building is square when diagonal measurements are equal.
FASTEN TO MAIN ROOF
BEAM WITH SCREWS
FASTEN TO ROOF
BEAM WITH SCREWS
FASTEN TO SIDE WALL
ANGLE WITH SCREWS
LEAVE HOLES OPEN
27
LEAVE SLOT OPEN
FASTEN TO GABLES
WITH BOLTS AND NUTS
27DG