Table of Contents
Advertisement
Step 8: Rear Siding
You will need for this page:
SS
SS
(QTY: 14)
(QTY: 24)
1
Slide bottom Rear Siding Panels into channels of Corner Posts and Splice Post as shown.
Once in place, secure with two (2) Small Screws per Panel. Screw going into bottom Floor
Frame also secure Stud.
2
Slide remaining Panels into channels, making sure Siding Panels overlap as shown. Once
overlapped, fasten each Panel using two (2) Small Screws as before.
3
Secure the tops of Panels to Rear Wall Angle using an additional one (1) Small Screw per
Panel.
4
From inside building, fasten all Rear Siding Panels to Corner Posts and Splice Post using
four (4) Small Screws per Panel.
Be certain all Siding Panels are
completely overlapped or holes
will not line up.
6
8736
Rear Siding
8736
8736
8736
Screw also secures
Stud to Floor Frame.
Washers are to be used on painted parts
only. Washers are not necessary on
unpainted parts and there are not enough
to use on every Screw and Bolt.
8736
8736
8736
6 21
21DG
Advertisement
Table of Contents
