Linking Atransmitter To A Single Receiver - Paralinx Tomahawk User Manual

LINKING A TRANSMITTER TO A SINGLE RECEIVER
20
LINKING A
TRANSMITTER
TO A SINGLE
RECEIVER
If there is no transmitter
registered to the receiver, you
should see a menu on the monitor.
These modes are set by the toggle
switches.
NOTE
Once the registration process has started on the receiv-
er, there is 30 Sec to start registration on the transmitter
side. If the registration process on the transmitter was
not started on time, re-start the registration process
by going back to step 4 listed above.
1 *Connect an HD-SDI cable from the Paralinx Tomahawk receiver to the HD display.
2 Turn on the transmitter and receiver.
3 Use the remote control at the Paralinx Tomahawk receiver and Press the "Add" Hotkey button.
4 The message "Please Activate the Registration on Transmitter Unit" will appear on the monitor.
5 Pressing the registration button on the transmitter until the "Network" LED starts blinking.
6 Wait for the message of "Adding [Tx name] Press OK to continue or Exit to cancel".
7 Press the "OK" button on the Remote control to confirm the new Paralinx Tomahawk transmitter.
8 Wait until the registration process is completed. The message of " Adding [Tx name]..."and progress bar
will be shown during the process.
9 Connect the HD Source to the Paralinx Tomahawk transmitter.
10 Video should be displayed on your monitors..
PARALINX TOMAHAWK
*The registration process can be done without HD source; the message will
notify you there is "no video source detected."