Water Reservoir; Maintenance - Wisco Industries 695D Manual

Food warming/merchandising cabinet
Hide thumbs Also See for 695D:
Table of Contents

Advertisement

The reservoir capacity permits uninterrupted operation for approximately 8-12 hours depending upon
settings and how frequently the door is opened.
The green lamp is designed to prevent overfilling of the water reservoir. Its only function is to indicate when
the reservoir is full and to stop adding water. As the water level recedes, the green lamp will deactivate.
When the red indicator light activates, it is signaling that the water level is low, and water should
be added to the unit immediately.

WATER RESERVOIR

On initial start-up, add distilled water to the reservoir until the green indicator light activates signaling that
the reservoir is full. We recommend using distilled water only to preserve the life of the electrical and
mechanical components.
If you do not have distilled water available for the initial operation of the unit, regular tap water may be
substituted. However, continued use of tap water over a period of time will result in diminishing efficiency
and eventual failure of the humidity control components.
The reservoir fill is located on top of the cabinet. Slide the cover open, and fill the reservoir with distilled
water. It is important to reposition the cover after filling the reservoir to maintain a sanitary environment
within.
NOTE: Reservoir capacity on initial fill is 3 quarts 8 ounces maximum. Refill capacity at the time the red indicator
lamp activates is 2 quarts maximum.
DRAINING WATER RESERVOIR: As a safety precaution, it is recommended that the 695 Display Warmer water
reservoir be drained prior to moving the unit. This is to prevent water from spilling into the food compartment or
onto electrical components.

MAINTENANCE:

TO REPLACE DISPLAY LIGHT
Only shatter resistant light bulbs which meet or exceed NSF Standards specifically designed for food holding
units must be used. Breakage of bulbs not specially coated could result in personal injury and/or food
contamination.
Disconnect the power supply cord, and wait until unit has completely cooled. Unscrew light, and replace
with a new specially coated bulb of the same style and wattage.
P .O. Box 10 • Oregon, WI 53575 • Ph: 608.835.3106 • Fx: 608.835.8273 • wiscoind.com • wiscomade.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

695d-s

Table of Contents