Leica GGo4 Technical Note

Gnss receiver

(tcpgps_android_en_v10_001_connect_with_leica_gg04_gnss_receiver)

Connect with Leica GG04 GNSS receiver

Update Date

15/09/2017

Hardware:

Leica GG04 GNSS recevier

Mobile device with Android OS v4.0.3+ and internal GNSS receiver.

Software:

Leica Zeno Connect v2.5.0.1141+ for Android

TcpGPS v1.0.0+ for Android

Objetive

Conectar TcpGPS para Android con el receptor GNSS Leica GG04 a través de

Leica Zeno Connect.

For connecting TcpGPS with the Leica GG04 GNSS receiver, Leica Zeno

Connect must be set up previously, which works as location provider for third party

apps.

These steps must be followed for setting up both programs:

 Go to Settings > Developer Options within the mobile device.

Sumatra, 9 E-29190 Málaga (Spain)

Web: www.aplitop.com

Phone: +34 952439771

Fax: +34 952431371

Technical Note

Table of Contents

Do you have a question about the GGo4 and is the answer not in the manual?

Page 1 Software: Leica Zeno Connect v2.5.0.1141+ for Android TcpGPS v1.0.0+ for Android Objetive Conectar TcpGPS para Android con el receptor GNSS Leica GG04 a través de Leica Zeno Connect. Details For connecting TcpGPS with the Leica GG04 GNSS receiver, Leica Zeno Connect must be set up previously, which works as location provider for third party apps.
Page 2  Select Leica Zeno Connect in the section Select mock location app.  Go to the main menu.  Turn on the internal GNSS receiver of the mobile device.
Page 3  Run Leica Zeno Connect.  Bound and select the Leica GG04 GNSS receiver in the Antenna section.  Create and set up a profile for receiving real time corrections.  Close Leica Zeno Connect.  Run TcpGPS.
Page 4  Go to Application > Settings and select Internal GNSS receiver in the Communications section.  Check that TcpGPS is receiving the desired accuracy on the GNSS receiver status screen. This accuracy must match with the accuracy shown by Leica Zeno Connect on the notification screen of the mobile device.