Configuring The Ni 5132/5133 In Max - National Instruments NI USB-5132 Getting Started Manual

The points will be 162 mm (6.375 in.) apart.
3. Remove the USB cable from the connector on the NI 5132/5133.
4. Screw a #8 or M4 screw into the bottom point on the panel.
5. Set the NI 5132/5133 on the screw by fitting it into the bottom screw notch on the
underside of the NI 5132/5133.
6. Screw a #8 or M4 screw through the NI 5132/5133 top screw hole into the panel.

Configuring the NI 5132/5133 in MAX

Use Measurement & Automation Explorer (MAX) to configure your National Instruments
hardware. MAX informs other programs about which devices reside in the system and how
they are configured. MAX is automatically installed with NI-SCOPE.
1. Launch MAX.
2. In the configuration tree, double-click Devices and Interfaces to see the list of installed
devices.
Note
installed devices. If the device is still not listed, power off the system, ensure
the device is correctly installed, and restart.
3. Record the device identifier MAX assigns to the hardware. Use this identifier when
programming the NI 5132/5133.
8 | ni.com | NI USB-5132/5133 Getting Started Guide
Figure 5. Mounting the NI 5132/5133 on a Panel
If you do not see your device listed, press <F5> to refresh the list of