Fitting The Brackets - Fisher & Paykel RF523G Installation Instructions Manual

Refrigerator not in a cavity:
• Brackets can be installed flush with the side of the refrigerator.

Fitting the Brackets

1. Determine where the front of your refrigerator
will sit. Mark this on the floor and measure back
towards the wall 678mm. This will determine
where the front edge of the bracket should be
placed (refer to A).
◦ The distance between the wall and the
back of the refrigerator must be a minimum
of 45mm and a maximum of 60mm. If the
distance is greater than 60mm, use a
spacer between the bracket and wall (refer
to B).
2. Determine if you are fitting the bracket to the
wall or floor. Place the brackets in the
determined location and mark the screw holes.
3. Fasten the brackets using pan head screws
◦ For wood or plasterboard wall/floor, use
the pan head self-tapping screw and screw
into a wall/floor stud. If there is no wall/
floor stud available, use a wooden spacer
before using the self-tapping screws.
◦ For masonry/tiled/concrete wall or floors,
drill a 6mm diameter hole with 40mm depth
and place the masonry anchor in the hole
before you screw the bracket down.
4. Locate the two holes on the rear of the
refrigerator (refer to C). Screw in the M6 cap
screws until all the thread is gone.
5. Move the refrigerator back towards the wall
until the screw hits the back of the bracket
(refer to D). Note: If you want your refrigerator
to sit further forward, unscrew up to 10mm of
the M6 cap screw. Be careful that the screw
does not miss the bracket and contact the wall.
https://producthelp.fisherpaykel.com/nz/Cool/French_Door/With_Ice_and_Water/790mm/RF523GDUX1/User_Guide_RF523G...
Updated: Sat, 15 Feb 2020 14:47:14 GMT
Powered by
6