Fisher & Paykel RF523G Installation Instructions Manual page 9

Connecting Water (Water dispensing and Automatic Ice models)
1. Ensure the refrigerator is NOT plugged into a
power supply. Locate the isolation tap for water
connection – cold water supply only. (Tee and
tap fitting not supplied).
2. Uncoil a tubing with quick fitting from the back
of the refrigerator (refer to A).
◦ The quick fitting is pre-assembled with the
tubing at the factory.
3. Connect one end of a long tubing (4m) to the
quick fitting, and insert the other end to a PLV
(refer to B).
4. Insert one end of a short tubing (200mm) to the
inlet of the PLV. (Refer to C).
◦ Ensure the arrow on the PLV is pointing
away from the tap. The arrow indicates the
direction of water flow.
5. Insert the other end of the short tubing firmly to
the tap connection. (Refer to C).
◦ The tubing should push in at least 16mm
before reaching the stop.
6. Pull gently on the short tubing to ensure it is
locked in place (refer to D).
7. Secure the connection by attaching a locking
key in between the tap connection and
locking collet (refer to E).
8. Fasten the tap connection to the cold water
supply tap. Take care not to over-tighten the
tap connection (refer to F).
The tap connection supplied
should fit most installation
situations.
9. Turn isolating tap on and check that all
connections are dry and free of drips.
https://producthelp.fisherpaykel.com/nz/Cool/French_Door/With_Ice_and_Water/790mm/RF523GDUX1/User_Guide_RF523G...
Updated: Sat, 15 Feb 2020 14:47:14 GMT
Powered by
9