Fisher & Paykel RF523G Installation Instructions Manual page 14

Hide thumbs Also See for RF523G:

What to Do if Your Product is Unstable

A. Gently push the refrigerator back until the rear rollers contact

the floor.

• Measure the gap under the front foot, which has come off

the floor.

• Obtain some solid packing material (hardwood,

plastic, etc) which fits firmly into the gap under the foot.

Note: Do not use metallic materials that may corrode,

stain and/or damage floor coverings.

B Wind both front feet up and roll the product out of position.

• Place the packing material in the location diagonally

opposite the front roller that lifts off the floor.

• Make sure the packing material stays in place when the

product is pushed back into position.

• Ideally, the packing material is large enough to rest

against the back wall to prevent it from moving when the

cabinet is pushed into position.

For example: if this foot lifts off the floor when pushing gently on the top front of the refrigerator

C. Roll the refrigerator back into position and adjust front feet as per page 16 step C (check alignment and door closing

action are satisfactory).

• Make small adjustments to front feet where necessary.

• Check that the product is stable (all 4 feet are on the floor). If not, repeat A and B.

https://producthelp.fisherpaykel.com/nz/Cool/French_Door/With_Ice_and_Water/790mm/RF523GDUX1/User_Guide_RF523G...

This foot lifts off the floor when top front is

gently pushed back

Updated: Sat, 15 Feb 2020 14:47:14 GMT

Table of Contents

Rf523m