Radiant GTS-TH-V Instructions

GTS-TH-V Thermostat Instructions
LCD symbols
Symbol Event
The buttons are locked
Heating is turned on
Set temperature
1,2,3,4
Program number
Manual mode
Power on Your Thermostat
When your thermostat is first connected to mains power, wait for about 30 seconds until the touch pad has self-adjusted.
Then press button to turn on/off the thermostat. When your thermostat is turned off, the LCD will display OFF.
POWER

Configuration Menu

To enter into the setting menu please follow the steps below:
Step 1, Turn the thermostat off by pressing
Step 2, Press , you will then see menu 1. At this step, if you press and hold "MENU", you will access to MENU 4 directly.
MENU
Step 3, Use the up and down arrows to adjust the "sensor selection" which is Menu 1(Air sensing, Air and Floor, or Floor only)
NEXT
Step 4, Press to move to the next Menu and once you have all the menu options set,
Setp 5, Press to accept and store.
DONE
Menu # Feature
1
Mode/Sensor selection
Maximum Floor Temp
2
( AF mode only)
3
5+2 / 7 Day Mode
4
Reset
Symbol Event
Automatic mode,
AUTO
executes the programmed schedules
OVERRIDE Temporary temperature override
Er
The floor sensor is not being read by the thermostat
Increase
Decrease
;
POWER
Explanation
This thermostat is a combination model which allows you to
choose 3 different modes.
A mode=Air Sensing Only(Has built in sensor)
AF mode=Air & Floor sensing(Floor probe must be installed)
F mode=Floor Sensing(Floor probe must be installed)
This is to protect the floor surface.
This allows you to program either 5 days at once, then the 2
days of the weekend separately, or a full 7 days at the same
time or 7 days separately
This allows you to reset your thermostat to factory default
See overleaf for further setting up information
Page1
ver 1.0
Adjustment
（press up & down buttons to adjust）
A, AF, F (F by default)
20 °C~ 40 °C (28 °C by default)
01 = 5+2 day programmable
02 = 7 day programmable(by default)
Press and hold the down button until you see RES on screen