Unpacking And Checking Contents - Bosch GCM12SD Operating/Safety Instructions Manual

2610051827 GCM12SD 08-18.qxp_GCM12SD 9/19/18 2:51 PM Page 13
Key Moldings / Positioning
Base Molding Against Fence*
38° Crown Molding Angled Against Fence*
45° Crown Molding Angled Against Fence*
Crown Molding Flat on Table
* Within miter range of 0° to 47° Left
Miter / Bevel
0°/ 0°
0°/ 0° with 3/4" table spacer
45°/ 0°
0°/ 45° (Left)
0°/ 45° (Right)
45°/ 45° (Left)
45°/ 45° (Right)
Unpacking the Miter Saw – When removing
this tool from packaging materials, reach down
to the two side carry-handle locations and
slowly lift until it clears the package.
saw by gripping any component of the mech-
anism support system.
This symbol is placed at various lo-
cations on the tool to warn the user
of pinch-point areas.
Loose Parts - 1 of each shown
6/4mm Hex Key
Miter Lock Knob
Cutting Capacities

Unpacking And Checking Contents

To avoid severe pinching,
never lift or move this
Workpiece Clamp
Maximum Size
3-7/8" (6-3/4" from 0° to 47° Left)
5-1/4" (5-1/2" from 0° to 47° Left)
6"
11-1/2"
Maximum Height x Width
3-1/2" x 13-1/2"
2-7/8" x 16"
3-1/2" x 9-1/2"
2" x 13-1/2"
1-1/2" x 13-1/2"
2" x 9-1/2"
1-1/2" x 9-1/2"
Checking Contents in Package – Open the top
of the package and look for the included loose
parts. Refer to the diagram below.
Some small parts such as the bevel lock lever
and miter lock knob require attachment to the
tool before it is ready for use – See "Attaching
Loose Parts" on page 15.
To avoid possible injury,
always disconnect plug
from power source before performing any as-
sembly, adjustments or repairs.
Check off for each part
Manual
Operating/Safety Instructions
13