Table of Contents
Advertisement
k Disc slot
l DISP/ /
Adjust screen brightness/contrast/
color.
Turn on/off the screen display.
m Adjust the display aspect ratio. MAP
MAPOpen the cover and insert/
remove the GPS map card.
n TUNE/
SELECT
Skip to the previous or next title,
chapter, or track.
Search backward/forward at
different speeds.
Start, pause or resume play.
Display the equalizer setting
interface.
o FM/AM
Switch to the FM/AM source
p USB socket
q AV IN
External equipment audio/video in
socket.
2 Get started
Caution
Use of controls or adjustments or performance
of procedures other than herein may result in
hazardous radiation exposure or other unsafe
operation.
Always follow the instructions in this chapter in
sequence.
Install the car audio
These instructions are for a typical installation.
However, if your car has different requirements,
make the corresponding adjustment. If you have
any questions regarding installation kits, consult
your Philips car audio dealer.
Caution
This unit is designed for negative ground
(earth) 12 V DC operation only.
Always install this unit in the car dashboard.
Other locations can be dangerous as the rear
of the unit heats up during use.
To avoid short-circuit: before you connect,
ensure that the ignition is off.
Ensure that you connect the yellow and red
power supply leads after all other leads are
connected.
Ensure that all loose leads are insulated with
electrical tape.
Ensure that the leads do not get caught under
screws orin parts that will move (e.g. seat rail).
Ensure that all ground (earth) leads are run to
a common ground (earth) point.
Use only the supplied mounting hardware for a
safe and secure installation.
When you need to change the fuse, consult a
professional.
EN
7
Advertisement
Table of Contents
