Table of Contents
Advertisement
Connecting water hose
1. Close the water valve and detach water pipe from
the water tank. Connect the t-shaped connector to
the water tank. Make sure that rubber packing is
inserted in between.
2.Connect the water pipe to the t-shaped connector.
Note: Please remove the regulator cover and regulate o-ring under the following conditions:
a.When the water dynamic pressure is lower than 0.05MPa, especially using
the family tank.
b.When the nozzle cannot work normally and water is low.
1、Take out the regulator with pliers and other tools.
2、Remove the regulator cover and regulate o-ring except the sealing o-ring.
3、Insert the regulator component into the inlet pipe.
Caution: Must use the regulator cover and regulate o-ring when the water pressure
is bigger than 0.1Mpa.
1
Regulator
Regulator
cover
3. Press the filter and washer at the two ends of
water hose into the screw tube, then connect the
main body and T-shaped connector with water hose.
Washer
Filter
1.Do not lift the product with the seat cover and seat open.
This may cause a mechanical trouble.
2.Cannot use with the hot water which temperature is higher
Prohibition
Sealing
o-ring
Regulate
o-ring
2
than 40 ° C .
3
4. Open the water valve to check if there is any
leakage.
Advertisement
Table of Contents
