Teleco Daisy Simple Instruction page 9

14.3 Remote memorization of other radio codes from standard transmitter
Note: The button P3 is located inside the standard transmitter. The added radio code will have the same functions as the code used for memorization.
This procedure is compatible with any type of transmitter.
Memorized
P3
Standard transmitter
Press button P3 of the memorized standard transmitter and hold. The buzzer emits a continuous sound. Press
a button relative to an already memorized code. The buzzer stops for 1 second and then starts the continuous
sound again. Press the virtual button on the Wise transmitter relative to the new code to be memorized. Successful
memorization is indicated by the intermittent sound of the buzzer.
15.0 Sending Scenario
1. Tap (Scenario
icon) to enter in the
next menu.
Via dell'Artigianato, 5 - 31014 Colle Umberto (TV) ITALY
Tel. +39.0438.388511 Fax +39.0438.388536
Web site: www.telecoautomation.com
G304BK-CO-SER1
16.0 Reset Wi-Fi Network configuration
* The memorized transmitters are not deleted.
Press (P) once and hold for 5s:
colore come G304BK-CO-SER
(5 s)
REV: 2.0
DATE: 01/06/18
Alternatively hold the button (P) down and at the same time turn on the power:
Memorized
continuous
sound
< 5 s
i
Scenario
2. Tap (Scenario
i c o n ) t o s e n d
scenario.
Button: Reset Wi-Fi
Network configuration (*)
Blue
Blue Red
Blue Red
...
1 s 1 s
1 s 1 s 1 s 1 s
Blue Red Blue
ON
...
0.5 s 0.5 s 0.5 s 0.5 s
New
continuous
sound Wise transmitter
1 s < 5 s
Daisy
Send Scenario
No Yes
3. Tap (Yes) to
send scenario.
Red
...
Red Blue Red Blue Red
...
0.5 s
0.5 s
...
i
Scenario
Note: Tap (i) icon to get information
about the scenario set.
... ...
Light1(Blue)
7CH(CH5)
2CH(CH2)
Blue Blue
...
0.5 s 0.5 s