Teleco Daisy Simple Instruction page 10

17.0 Troubleshooting (what to do IF...)
Problem
First configuration procedure:
Blue and Red LEDs flashes alternately for long time
First configuration procedure:
Blue Led flashes slowly - Connection failed
First configuration procedure:
GPS connection problem
Normal operating mode:
Disconnection from the WiFi network: Blue and Red LEDs
flashes alternately
Normal operating mode:
No internet connection - Blue LED flashes each 0.3s.
Normal operating mode:
Emergency mode - Blue LED flashes each 0.1s
WISE APP
Solution
Wait until the LEDs stop flashing even if appear the
message "Connection between board and phone
failed".
If the LEDs continue to flash, check that the router
does not have filters blocks set.
Check that the data are correct and repeat the first
installation procedure.
Verify that the GPS function is enabled and set to
high precision mode
Verify that the router is powered and connected to
internet.
Check the router's internet connection
Via dell'Artigianato, 5 - 31014 Colle Umberto (TV) ITALY
Tel. +39.0438.388511 Fax +39.0438.388536
Available only direct commands.
Web site: www.telecoautomation.com
.
Check the router's internet connection
RED LED
colore come G304BK-CO-SER
REV: 2.0
DATE: 01/06/18
G304BK-CO-SER1
DAISY BOX
BLUE LED