Teleco TXQ 868 A42 Programming Manual

Programming of your new remote control :
There are several methods for programming your new remote control.
From a remote control that has already been programmed :
1. Approach your receiver so you are standing 1 or 2 feet away from it.
2. Press the P button on your new remote control as many times as necessary to select the
channel position on which you want to record your new operation (the position is indicated
by the red LED light).
3. With a sharply pointed object, press the hidden button behind your already-programmed
remote control. Let it go. The receiver emits a beep.
4. Press the button you wish to program on your new remote control. Let it go. The beep stops
then starts again for 5 seconds.
5. Press again the same button on your new remote control until the receiver emits an
occasional beep.
6. Wait 10 seconds.
7. Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
TELECO TXQ 868 A42
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151