Operation - Bunker Hill Security 64759 Owner's Manual & Safety Instructions

Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Initial Battery Charging
Before the Security Light can operate properly, the
battery needs to be fully charged. To charge the battery:
1. Turn OFF the Power Switch.
2. ALLOW 3 DAYS OF FULL SUNLIGHT
to fully charge the battery.
3. After charging, turn the Power Switch to
Auto. The light will illuminate for a short
time when first switched to Auto. This
indicates that it is working properly.
Power Switch
The Power Switch, located under the Battery
Housing of the Lamp has three settings:
OFF: Center position.
ON: Towards the Lamp. The lamp stays
on functioning as a normal light.
AUTO: Away from the Lamp. The light
will turn on automatically when motion is
detected by the Motion Sensor Head.
Motion Detector Control Knobs
The Solar Powered Security Light has 3 different
Control Knobs on the underside of the Motion Detector
Head. They control the Motion Detector Head's sensor.
They are sensitivity to light (LUX), the light's duration
(TIME) and the sensor's sensitivity to motion (SENS).
After making adjustments, walk the detection
area to check adjustment just made.
Page 6 For technical questions, please call 1-888-866-5797.
CAUTION
The UNIT WILL NOT FUNCTION
UNLESS:
The Solar Panel is first charged for
3 DAYS OF FULL SUN
with the SENSOR POWER OFF.
OFF
AUTO
Note: If the Power Switch is turned on but the Security
Light does not light, the battery may need to be charged.
Power off the Security Light and allow it to charge
3 days in full sunlight to fully charge the battery.
SENS
Adjusting
Adjusting
Knob
SENS TIME
Located on the bottom of
Motion Detector Head
ON
TIME
LUX
Adjusting
Knob
Knob
LUX
Item 64759