Bunker Hill Security 64759 Owner's Manual & Safety Instructions page 8

Motion Detector Control Knobs (cont.)
LUX (Light Level)
Adjust Light Level
(when the light will go ON)
The LUX Adjusting Knob tells the sensor
the level of darkness that must be
reached before the Light turns on.
Testing the Light
1. After the battery is charged and the control Knobs
are set, walk slowly around the detection area.
The sensor detects infrared radiation given off
by a person or animal. This triggers the Light
to turn on. The Light should go on in the area
that you set up the Security Light to monitor.
Page 8 For technical questions, please call 1-888-866-5797.
Minimum Position
Turning the dial
counterclockwise to the
minimum setting lowers the
sensor level. The sensor
will only trigger the light to
turn on at dusk or when
it is dark out. This is the
ideal position for general
evening and night operation.
Maximum Position
Turning the dial clockwise to
the maximum setting increases
the sensor level. The light
will go on in most situations
ranging from dark to daylight.
Note: If the Security Light is
not operating at night due to interference from a
street light or other interference, turn the LUX knob
towards the maximum setting (
as needed between the minimum and maximum
settings to achieve the desired level of sensitivity.
2. Adjust the Knobs and sensor and re-test
until the unit functions as desired.
3. Repeat the test procedure as needed when there
are weather and/or temperature changes.
). Adjust the dial
Item 64759