PRIME 3 SAP81 Owner's Manual page 9

SAP81
Description of the device function
1. Smart Mode (6) - in Smart mode, the device will adjust the work to the level of pollution. PM2.5 particle level
below 60 (basic speed), below 150 (average speed), above 150 (high speed).
2. Purifying speed (7) - the button allows you to control the purifying speed, basic (500RPM), medium
(700RPM), high (900RPM).
3. Night mode (8) - After pressing the button, the device will go to night mode after 5 seconds. In this mode,
the device operates at the basic purifying speed and the control panel backlight is turned off. Press any button
to exit the night mode.
4. UV Sterilization (9) - press the UV sterilization button to turn the device on or off.
5. Timer (11) - pressing the button will start the timer function, each press extends the working time by 30
minutes. The minimum time is 30 minutes, maximum time is 12 hours. Press and hold the button for 3 seconds
to turn off the timer function.
6. Ionizer (12) - pressing the button will start the air ionization process. The ionization icon will be highlighted.
7. Child lock (13) - pressing the button will cause the buttons to not react to pressing, and the device will
operate in the previously selected operating mode. Press and hold the button for 3 seconds to disable the
lock. The icon will be illuminated when the child lock is on.
8. Purifying speed indicator (14) - the indicator shows the current air purifying speed, basic (500RPM), average
(700RPM)
Remote control:
The device has been equipped with a remote control powered by button batteries (CR2032). The remote
control has the same set of buttons as the target device.
Comments:
Before first use, open the battery cover and remove it from the packaging. Then re-insert, otherwise the
remote control will not work. If you do not intend to use the remote control for a long time, remove the
battery.
Clock settings:
1. Press and hold the Smart Mode button (6) for 5 seconds to activate the clock settings. Use the purge speed
(7) and night mode (8) buttons to set the hour. Press the Smart Mode button (6) once again to go to the
minute settings; set the number of minutes using the cleaning speed (7) and night mode (8) buttons, wait a
few seconds and the set time will be saved.
9