Cleaning And Maintenance - PRIME 3 SAP81 Owner's Manual

SAP81
1. Control panel.
2. Air inlets.
3. Air outlet.
4. Handle.
5. Front panel.
Control panel buttons:
6. Smart Mode.
7. Cleaning speed.
8. Night mode.

CLEANING AND MAINTENANCE

Do not immerse the device in water. Wipe the surface with a damp cloth, then wipe dry.
Before carrying out maintenance work, make sure that the device is disconnected from the power supply.
The pre-filter is washable, it can be cleaned in water, dry the filter before further use.
Filters (cold catalysis + activated carbon + antibacterial + HEPA) are not washable; do not immerse them in
water. The filters can be cleaned using a vacuum cleaner with a soft brush. The filters are extremely delicate;
they must not be pressed too much when vacuuming.
If the device is operated under normal conditions, it is recommended to replace the filters every 6 months
(cold catalysis + activated carbon + antibacterial + HEPA) assuming that the device works approx. 8 hours a
day. In case of strong air pollution or prolonged use, the filter may require more frequent replacement. It is
recommended to clean the filters every 60 days. It is recommended to clean the pre-filter every 15 days.
Maintenance of the ionizer head (Fig. 3)
It is recommended to clean the ionizer head from the dust with a dry brush, if the device starts to make
sounds resembling crackles. Insert a soft brush through the air outlet opening above the ionizer head.
Regularly remove the dust that accumulates near the ionizer head.
Maintenance of the particles sensor (Fig.4)
Pollution sensor - it is recommended to clean the particle sensor every 2 months. To clean the sensor, remove
its cover and then clean the lens with a dry cotton swab.
Installation / replacement of filters (Fig.5):
1. Press in the points marked on the picture to unclip the front panel of the device.
2. Remove the front panel.
3. Remove all filters from the device.
4. Remove the HEPA + antibacterial filter, the cold catalysis filter + activated carbon filter and the pre-filter
from plastic packaging.
5. Insert the HEPA + antibacterial filter so that the side with the handle is facing you.
6. Insert the cold catalysis filter + activated carbon so that the side of the handle is facing you.
7. Insert the pre-filter so that the side of the handle is facing you.
8. Install the front panel.
Switching on the device
· On / off switch (10) - press the switch to switch on the purifier. The device will automatically switch to the last
saved operating mode (excluding the timer and night mode settings). The device will not turn on if it is not in
an upright position or the front panel is not correctly installed).
· Press the button to turn off the device.
9. UV sterilization.
10. ON / OFF switch.
11. Timer.
12. Ionizer.
13. Child lock.
14. Purifying speed indicator.
15. Filter replacement indicator.
16. Air quality indicator.
8