Main Unit Rear Panel - Sony NSP-100 Operating Instructions Manual

Main Unit Rear Panel

1 S VIDEO connector
1 S VIDEO (S-video output) connector (mini-DIN
4-pin)
This outputs the playback video as an S-video signal.
2 COMOPOSITE connector (BNC type)
This outputs the playback video as an analog composite
signal.
3 G/Y, R/R−Y, B/B−Y (component video output)
connector (BNC type)
This outputs the playback video as an analog component
signal. A DIP switch setting controls whether this is Y/
R−Y/B−Y signals or RGB signals.
4 AUDIO OUT 1 and 2 connectors (pin jacks)
This outputs the playback audio as an analog signal. For
a stereo signal, connector 1 outputs the left channel, and
connector 2 the right channel.
(network) connector (RJ-45 modular jack)
5
This is a 100BASE-TX connector for network
(Ethernet) connection.
Caution
When using a LAN cable: For safety, do not connect to
a connector for peripheral device wiring that might have
excessive voltage.
6
Names and Functions of Parts
2 COMOPOSITE connector
3 G/Y, R/R
VIDEO OUT AUDIO OUT
G/Y
1
COMPOSITE
S VIDEO
2
R/ B/
R-Y B-Y
− −
Y, B/B Y connector
4 AUDIO OUT 1 and 2 connectors
VIDEO
NTSC COMPONENT
1
2 PAL RGB
RS-232C/GPI
6 RS-232C/GPI connector
5 Network connector
6 RS-232C/GPI (general-purpose interface)
connector (D-sub 9-pin, male)
Connect to the D-sub 9-pin connector of a plasma
display or video monitor.
7 DIP switches
The settings of the four switches relate to the output
video signal format, output component video signal, and
remote controller. The diagram of DIP switch settings
above the switches shows the significance of the two
positions ("1" and "2") for each switch.
DIP switch setting diagram
1 NTSC COMPONENT
2 PAL
VIDEO (output video signal format/output
component video signal settings)
NTSC/PAL (leftmost switch): Select the output video
signal format.
COMPONENT/RGB (second switch from left):
Select output of a Y/R−Y/B−Y signal or RGB signal
from the G/Y, R/R−Y, B/B−Y connector.
IRD REMOTE
ON 1
OFF 2
1
2
7 DIP switches
VIDEO IRD REMOTE
ON 1
RGB OFF 2
1
2