Setting "Menu Language - Sony NSP-100 Operating Instructions Manual

• Plasma control
Select this when using a plasma display.
Use the following procedure.
1
In the "System Administrator Setup" screen, carry
out any of the following.
• Press numeric button 3, then press the ENTER
button.
• Using the v and V buttons, select "3. RS-232C
Setup Menu," and press the ENTER button.
The "RS-232C Setup" screen appears.
To return to the "System Administrator Setup"
screen
Carry out any of the following.
• Press numeric button 1, then press the ENTER
button.
• Using the v and V buttons, select "1. Back to
System Administrator Setup," and press the
ENTER button.
2
Carry out any of the following.
• Press numeric button 2, then press the ENTER
button.
• Using the v and V buttons, select "2. Control,"
and press the ENTER button.
The setting can now be changed.
3
Using the b and B buttons, select the desired
setting, and press the ENTER button.
• When anything other than "Plasma Control" is
selected, the setting is confirmed.
• When "Plasma Control" is selected, continue to
step 4.
22
System Administrator Setup
4
Using the b and B buttons, select the plasma
display to be controlled, and press the ENTER
button.
This confirms the setting.
To exit the "RS-232C Setup" screen
Carry out any of the following operations.
• Press the MENU button.
• Press numeric button 1, or using the v and V buttons,
select "1. Back to System Administrator Setup," and
press the ENTER button.
To enable the new RS-232C settings, a message prompt
appears, asking if you want to reset the unit.
To reset immediately, select "Yes"; to reset later, select
"No."
The standby screen or "System Administrator Setup"
screen appears after a reset (for "Yes") or immediately
(for "No").

Setting "Menu Language"

You can select Japanese or English as the menu
language.
Note
When "PAL" is selected as the output video signal
format with the DIP switches on the rear panel (see
page 6), the menu language selection function is not
available.
Use the following procedure.