Kenwood TS-590S Setting Manual page 7

Run-time
ARHP-590
VoIP software To transmit and receive audio, VoIP software is required. (See Note 1.)
LAN Router
environment
Modem
Other
Internet Provider
environment
Proxy
Note 1: Support for selecting, installing, and operating VoIP software is not available from
Kenwood Corporation.
Note 2: Make sure to refer to the user manual for the broadband router to be used before
performing the settings.
Note 3: KNS operations are possible even if the global IP address is variable, but the IP
address may change with uncertain timing. In such cases, it is necessary to check
and change the IP address of the connected host when connected from a remote
station, which reduces user-friendliness. Consequently, using an environment in
which the host station global IP address is fixed is recommended. Furthermore, if the
global IP address cannot be fixed, using a dynamic DNS service enables operations
in the same way as an environment with a fixed global IP address.
To use KNS on Windows XP, Microsoft .NET Framework 2.0 or later is
required. If it is not installed, install it when installing ARHP-590.
This software controls the transceivers. Refer to the software help for
the settings and operation methods. Download the software from the
download page, and install on the PC.
http://www.kenwood.com/i/products/info/amateur/software_download.html
To implement KNS operations via the internet, a model on which port
forwarding settings are possible using the following protocol is
required to transmit the data signals that control the transceiver. (See
Note 2.)
Protocol: TCP; port No.: 50000 (KNS default value)
Not specified.
To implement KNS operations via the internet, firewall environments
configured using in-house company networks cannot be used. Use a
domestic network environment.
To implement KNS operations via the internet:
・ A high-speed cable broadband environment using xDSL, FTTH, or
CATV network is required. (1Mbps min. recommended.)
・ A global IP address is required. (See Note 3.)
・ The ability to use protocols and ports to transmit the data signals
that control the transceiver is required.
Protocol: TCP
Port No.: 50000 (KNS default value)
For details, contact your internet service provider.
Proxy servers cannot be used.
7