i3 International SBB41 Quick Start Manual

SBB41 Installation Guide
In the event that you must install a new SBB41 please follow these instructions.
Before beginning please ensure that:
• The packing foam used during shipping of the NVR system has been
removed from between the outer door and the front of the SBB41 units.
• That the NVR is powered down and disconnected from the power source
and other connections to the NVR.
• It is paramount you properly ground yourself. Use an anti static strap to
ensure you stay grounded throughout the procedure.

INSTALLATION INSTRUCTIONS

1. Remove the Hard Drives from the SBB41 unit and carefully set them aside. If
the drive is not numbered make careful note of which drive came from which
bay. They will need to be in the same bay in the new SBB41
2. Remove the screws securing the lid of the NVR.
i3 INTERNATIONAL INC.
1.866.840.0004
www.i3international.com
U.S.A 4450 Witmer Industrial Estates Unit 4
Niagara Falls, NY 14305

Quick Start Guide

3. Once all the screws are removed lift the back of the lid and remove it from
the chassis.
4. Below is a view of the back of the SBB41 from inside the NVR chassis. Here
you can remove the Sata cables and the power cables from the SBB41. Be
sure to take particular note which Sata cable came from which drive bay.
They will need to be connected back to the same drive in the new SBB41.
5. Remove the 18 screws that secure the top bracket. 6 screws along the sides
and 12 on the top surface. These screws on the top simultaneously secure
the top bracket and the SBB41 to the chassis.
Canada 780 Birchmount Road, Unit 16,
Scarborough, ON, M1K 5H4
SBB41
Rev. 161110