Auto 2 Memory Storage - Extech Instruments 407790A User Manual

5.5 Auto 2 Memory Storage

Memory Store
Continuously store the processed data at a preset measurement integrated time.
1. Power on the meter.
2. Press the MENU button to enter the menu list screen.

+
3. Use the /

+
4. Use the /
Selecting FLASH will store the data in the internal memory.
Selecting SD Card will store the data on the SD CARD.

+
5. Use the /

+
6. Use the /

+
7. Use the /

+
8. Press the
1 second to 23h59m59s, then press the  key.

+
9. Use the /

+
10. Use the
23h59m59s, then press the  button.
Note: Measurement Time must be greater than or equal to the set Interval Time
11. Set the other measurement parameters (trigger mode, sub channel etc.) as required, using
the MENU button to select settings.
12. Press the MENU button to return to the measurement screen.
13. Press the R button to start the measurement. If a trigger has been set, measurement will
start when the trigger conditions are met.
The AUTO recording of data can only be read using the PC software.
It cannot be recalled by the meter.

-
buttons to select "B) . Storage" then press the  button.

-
buttons to select "FLASH" or "SD Card" then press the  button.

-
buttons to select "C*) . Store Mode" then press the  button.

-
buttons to select "Auto 2" then press the  button.

-
buttons to select "Integrate Time" then press the  button.

-
and the  buttons to set the desired measurement integrated time from
/

-
buttons to select "A) . Measurement time" then press the  button.

-
and  buttons to set the desired measurement time from 1 second to
/
44
407790A-EN_V2.4 1/20